Telit Wireless Solutions BLUEMOD+S42/AI/ADC/LUA, Руководство пользователя

Страница: 29 / 85

S42
Hardware User Guide
1VV0301303 Rev. 11
Page 29 of 85 2021-05-06
Not Subject to NDA
C
L
= (C1+C
pin
+C
s
) * (C2+C
pin
+C
s
) / (C1+C2+2*C
pin
+2*Cs), or
C1, C2 = (2*C
L
– C
pin
– C
s
)
C
pin
: see Table 6
C
s
: stray capacitance, depends on layout
Figure 15: S42 connection of external XTAL
3.10. Test Mode
For homologation purposes, the ability of test mode opera tion like “S42
Testmode” or “Direct two wire UART Testmode” (DTM) is mandatory. The Direct Test
Mode (as defined by the Bluetooth SIG) and S42 Testmode are part of the
S42 firmware. Please refer to
[6] and [7] . For EMC measurements the use of
the S42 Testmode is recommended.
For enabling the different test modes, the S42 provides two IO pins.
•
The pin Testmode is low active. Active in the following table means connect to
GND.
•
The pin Boot0 is high active. Active in the following table means connect to VDD.
• The other two combinations start the bootloader for firmware update of the
programmed firmware. These two modes are not scope of this document.
The following table shows the possible combinations:
Testmode# Boot0 Mode
Active Inactive Testmode (38400, 8N1)
Active Active DTM (19200, 8N1)
Inactive Active Bootloader (15200, 8N1)
Inactive Inactive Firmware
Table 7: Testmode# / Boot0 Logic
To enter and use S42 Testmode or DTM, access to the following signals is
required:
• BOOT0
XL-IN
S42
A-6
Slow Clock
XL-OUT
A-5
32,768kHz
CL: 9pF
C1
C2
C1, C2 ~ 12pF