Telguard FlexHub TGFX-HUB1, Руководство по установке

Страница: 23 / 29

Model TGFX-HUB1 © 2018 Telguard 23
REMOVE AN ORPHAN Z-WAVE DEVICE
If a Z-Wave device is an orphan (it belongs to another network) it must be removed from its current
network before it will try to join the FlexHub network. From the Devices tab, select the right arrow
next to FlexHub Devices. Then select the Delete Orphan Device button.
The FlexHub will enter exclusion mode as indicated by the flashing Z-Wave LED. As with adding and
removing a device, be sure you are also ready to place the new Z-Wave device into exclusion mode.
If required, refer to the device manufacturer’s documentation to activate the “Exclude” function
because many devices do not use a physical button to start the exclude process.
Once the orphan device is removed, the Z-Wave light will stop flashing. If an orphan device is not
found, the exclusion mode will end after 1 minute.
REMOVE/REPLACE A FAILED Z-WAVE DEVICE
When a Z-Wave device has failed, it may no longer respond to a button press to remove it from the
network. In that case, follow the instructions above for removing a device. The FlexHub will recognize
the failure and remove the device from the network without a button press.
If an identical Z-Wave device is to replace the failed device, select the device icon or the right arrow
next to the device icon to open the device details page. Tap the Replace Device button to exclude the
failed device and include the new device in its place.
Be sure you are ready to place the new Z-Wave device into “Include” mode. If required, refer to the
device manufacturer’s documentation to activate the “Include” function because many devices do not
use a physical button to start the include process.
Ideally, the new Z-Wave device should be located near the controller. For door locks, many
manufacturers recommend placing the lock no more than five feet from the controller.
Once the new device is discovered by the FlexHub, the Internet light will begin to flash, indicating the
the FlexHub is resetting its connection with the HomeControl Flex server to report the new device.
If the FlexHub does not find a new device to add within 1 minute it will exit inclusion mode and return
to normal operation.