TLV-400S H.264/MPEG-2 Professional Digital TV Receiver User’s Manual
SUB/OSD
Enable or disable OSD on composite display (PSIP display,
FAULT status display and Volume bar, Constellation)
3.2.4 CONFIG/RF-IN1 sub-menu
To configure RF related modes. There are RF-IN1 and RF-IN2 sub menu.
Table 16 CONFIG/RF-IN1 sub menu architecture
CONFIG
RF-IN1
Configure RF input-1 source.
RF-IN1/ SYSTEM
Select system type : DVB-S, DVB-S2
RF-IN1/ IF FREQ (in case
LNB TYPE : MANUAL
MODE)
Switch MAIN channel source into RF-IN1 and Tune by entering
frequency with numeric button. The unit is KHz.
RF-IN1/ SATELLITE FREQ
(in case LNB TYPE :
SINGLE or UNIVERSAL)
Switch MAIN channel source into RF-IN1 and Tune by entering
frequency with numeric button. The unit is KHz.
RF-IN1/SYMBOL RATE
Set the symbol rate of RF-IN1.The unit is KSps.
RF-IN1/FREQ SEARCH
RANGE
Set the frequency search range from 1MHz to 5MHz. When the
RF input signal is weak, the receiver will automatically scan in
the range of the value.
RF-IN1/LNB
Select LNB setting of RF-IN1. It consist of LNB TYPE, LNB
POWER, LNB TONE, DISEQC 1.0, DISEQC 1.1, DISEQC
COMMAND REPEAT.
RF-IN1/LNB/LNB TYPE
User can choose frequency entering mode. Please choose
SINGLE, UNIVERSAL or MANUAL MODE(ENTER IF FREQ) :
default option is MANUAL MODE.
CONFIG/RF-IN1/LNB/LNB TYPE/SINGLE : User need to set LNB oscillator frequency and enter
satellite frequency. The receiver calculate the L-BAND frequency by taking difference of the
satellite frequency with LNB oscillator frequency.
CONFIG/RF-IN1/LNB TYPE/UNIVERSAL: User need to set two LNB oscillator frequency and enter
satellite frequency. The receiver select high part of LNB oscillator or low part of LNB frequency
depending on the satellite frequency. The receiver calculate the L-BAND frequency by taking
Version 1.8 34
