Televes OSSGT, Руководство по эксплуатации

Страница: 8 / 16

8
ELECTRIC-ARC FUSION SPLICER
4.2 Splice Mode
In this mode, all the parameters related to the splicing
process can be modifi ed:
Parameter Description
Fiber type
Allows to select between 8 diff erent types of
fi ber. By defalult, the “SM” option is confi gured.
Splice Mode
Allows to select between 5 diff erent types of
splicing modes. By default, the “Auto” option
is confi gured.
Splice program
Nº
Allows to choose between the diff erent splice
programs.
Edit splice
program
Allows to modify the parameters of the
selected splice program (see section 4.2.1)
Clean Arc
duration
The splicer makes a “pre-arc” that erases any
possible defects present on the fi ber before
splicing. This option allows to modify the
duration of the cleaning operation (by default
the value is 120ms).
Core angle limit
By default 3º, allows to confi gurate the
maximum angular limit between cores to
perform the splicing process.
Fiber angle limit
By default 0.8º, allows to confi gurate the
maximum angular limit of the fi ber to perform
the splicing process.
Fiber deviation
limit
By default 0.4um, allows to confi gurate the
maximum limit of deviaton between fi bers to
perform the splice.
Loss limit
Maximum loss value acceptable.
Values higher than selected will be indentifi ed
as inadecuate.
By default is confi gured with a value of 0.05dB.
Manual ReARC
time
This parameter allows the modifi cation of the
enhanced duration of the arc (usual value:
1000ms). It can be increased in case that after
splicing, there is narrowing detected on the
fi ber at the splicing spot. If the fi ber is thicker
on that spot (forms a bulge), it can be reduced.
These values are seldom modifi ed.
Align mode
Method used by the splicer to align the
fi bers (core or cladding). Always should be
confi gured by “Core” mode.
Quick splice
If this option is activated, the splicer will
perform a splice in less time.
Force splice
Forces the splice process to begin if the option
is activated.
4.2.1 Edit splice program
In this option, the parameters of the splice program
previously selected can be modifi ed by the user.
Parameter Description
Pre-splice
duration
Duration of the process previous to splicing.
By default 120ms.
Pre-Arc
power
Pre-arc discharge power (in bits).
Splice duration Time pulse (us). Never modify this value.
Arc power By default 801 bits. Never modify this value.
Overlap
Mounting or pushing a fi ber on top of another
when splicing (in

m).
It controls the thickness of the fi ber at the
splicing spot, once the splicing process is
complete.
Approximation
speed
Approximation speed of the fi bers. By default
the value is set in 30

m/s.
Activate 2nd arc
If this option is activated, the device will launch
a second arc after the splicing process is
complete to erase dirt.
4.3 Heating mode
In this option, the heating parameters can be modifi ed by
the user, as well as the heat-shrink protectors, heating
temperature and the duration of the same.