Teletronics International Inc.
CPE Complete User Manual
Page 18 of 27
Step 4:
Setting up the
ether1
adapter. Click on the default IP (192.168.1.1) to
modify it. The default values will appear in the IP, Net Mask, and Comment
fields. Make your modifications, and then click on the
Modify
button.
After your modification have been made, checks will appear at the right to
indicate weather or not your changes were appropriate. If you have chosen
IPs that are in conflict, you will be notified with "x"s.
Appropriate Modification
Inappropriate Modification
•
Important Note: Now that you have modified your
ether1
adapter, after you click the
Activate
button or the
Save and Reboot
buttons, you must enter the CPE
Configuration Utility through the new IP, in this case, https://192.168.1.2.
Step 5:
Setting up the
wlan1
adapter. By default, the wlan1 adapter is not setup.
Enter these following values into the following fields:
When you have completed value entries, click the
Create
button. If there are
no IP conflicts, the software will allow the modifications.
