Teletronics International Inc.
CPE Complete User Manual
Page 17 of 27
6.0 Setting up the CPE as an Access Point
===============================================================
•
The following explanation and screen shots will demonstrate how to set the CPE as
an AP. The IP addressing explained in this section will reflect the IP addressing as
seen in
Diagram 3.0
.
•
You can save your changes after you have made modification, however, they will not
come into effect until you either
save and reboot
, or
activate
. These options are
located at the top left of the CPE Configuration Utility screens.
•
Be aware of the
Update
buttons at the bottom of some configurations screens. Be
sure to click the update buttons, if you have made any changes, before moving on to
other configuration options.
Step 1:
Log into the CPE (See Section 4.0 - User Interface)
Step 2:
Select
Assign W/LAN IP Addresses
from the menu on the left
Step 3:
Click on
All Ethernet and Wireless Adapters
•
In
Diagram 3.0
, the AP has an Ethernet IP of 192.168.1.2, a radio card IP of
192.168.2.1. The radio card gateway is set at 192.168.1.1. Both cards have a subnet
mask of 255.255.255.0.
