14
Status field:
This section shows the measured parameters. The left side shows the name of the parameter. On
the right side is the parameter.
System Status:
‘OK’: Encoder module is works perfectly, ‘ERR’: Problem with the
encoder unit.
Video Status:
‘OK’: SDI video signal is connected, ‘Not Connected’: SDI video signal is
disconnected.
Video bitrate:
The value of the video bitrate in kilobit per seconds. This value comes
from the system bitrate and audio bitrate. Also depends on the PSI tables.
Audio Status:
Indicates that there are embedded audio: ‘Audio is Present’ or ‘No Audio’:
Muted
Settings field:
In this section can be set the parameters. The left side shows the name of the parameter. On the
right side can be change any parameter.
Own IP:
The IP address of the UDP/IP marked port
Own MAC:
The MAC address of the UDP/IP marked ETH port.
Own TS Port:
The source TS Port.
Gateway IP:
The IP Address of gateway if we use ‘Through gateway’
TS sending
Target IP:
The IP address of the destination side (DECODER).
Multicast MAC:
The MAC Address of multicast sending in ‘To multicast’
mode in hexadecimal format.
Stream Port:
The destination port of TS.
System Bitrate:
The full TS bitrate in kbps.
PMT, Video, Audio, PCR PID
The PID values: PMT, VIDEO, AUDIO, PCR you can
specify in hexadecimal format. The possible values of PIDs
are in 0x0020 … 0x1FFF range.
Program ID:
The Program identifier in hexadecimal format. The possible
values of this ID are in full 0x0000 … 0xFFFF range.
Program Provider:
The name of the program provider in maximum 20
characters.
Program Name:
The name of the program in max. 20 characters.
Stream ID:
The identifier of the TS in hexadecimal format. The
possible values of this ID are in full 0x0000 … 0xFFFF
range.
