Copyright © 2013
Teleste Corporation
Optimo
Server Installation Guide and Release Notes v2.0.2
12
APPENDIX A: CONFIGURE DETAILS
The configure program is run to configure a new system or upgrade an existing system with new
software. It behaves like a standard command line utility. It is interactive by default, requesting simple
input from the user. However, there are command line options you can enter to install automatically,
which is important when installing multiple machines over ssh.
The following is the command for usage help:
./elemental_production_server_2.0.2.####.run --help
OPTIONS:
-i <filename>:
Use the configuration XML <filename> to configure
-h, --help :
Show this help message
-v, --version:
Show version information
-s, --start:
Start the services once installed without asking
-c, --cleandb:
Clean out databases before updating
-t, --skip-tz
Bypass entering time zone settings
-n, --skip-net:
Bypass entering network settings
-l, --skip-cluster:
Bypass entering cluster settings
-z, --skip-auth:
Bypass entering authentication settings
-a, --config-auth:
Configure authentication settings only (does not run
full configure)
-e <port@host>:
Set license server location port@host. For example:
2701@licserv1
--skip-all
Bypasses time zone, network and authentication
settings
-ns, --no-start:
Don't ask to start the service at the end of
installation
-xeula:
Bypass the display and prompting for acceptance of
the End User License Agreement. By
using this option, you indicate that you have read
and accept the License Agreement contained in the
file
opt/elemental_se/doc/ESAE_EULA.txt and in the About
section of the user interface
--install-driver <driver>: Install one of the following drivers during a
system update: celerity8fc
