Telesis PINSTAMP TMP4100 Series, Установка и обслуживание

Страница: 42 / 62

TMP4100-Series Installation/Maintenance
2-14
33480D01.DOC
2.8 REPLACEMENT PROCEDURES
Authorized replacement of the TMP4100-Series marking head components are listed in the following
paragraphs. Component replacement procedures not explicitly contained in this document must be performed
by repair agencies authorized by Telesis Technologies, Inc.
2.8.1 Impact Pin / Pin Cartridge
Follow the steps below to remove and replace the impact pin and/or the pin cartridge assembly.
C A U T I O N
The impact pin and pin cartridge do not require lubrication.
The plastic pin cartridge may become obstructed if lubricated.
Removal
1. Remove electrical power from the marking system.
2.
TMP4100, TMP4150, TMP4155:
Remove air pressure from the marking system.
3.
TMP4150, TMP4155:
Remove the marking head cover:
a. Lift up on the tabs of the latches located on the sides of the marker.
b. Rotate the tabs counter-clockwise to loosen and disengage the latches.
c. Slide the protective boot over the end of the cartridge.
d. Slide the cover off the marker.
4. Remove two screws that secure the cartridge to the manifold.
5. Gently tip the pin cartridge allowing the impact pin to slide from the open cartridge bore.
6.
TMP4100E:
Remove the return spring from the pin cartridge.
7. If you are re-using the same cartridge, clean the cartridge bore with isopropyl alcohol. Use care to
prevent contaminants from entering the bore.
Installation
1.
TMP4100E:
Install the return spring on the small diameter of the impact pin.
2. Insert the impact pin into the cartridge bore.
3. Apply
VIBRA-TITE
®
to the two screws (removed from the cartridge).
Allow the
VIBRA-TITE
®
to dry before continuing.
4.
TMP4100, TMP4150, TMP4155:
Align the return air port (hole) of the pin cartridge with the hole in the
manifold.
5. Press the cartridge into place and secure with the two screws. Tighten securely, but do not over tighten.
6.
TMP4150, TMP4155:
Install the marking head cover:
a. Slide the cover off the marker.
b. Engage the latches and rotate the tabs clockwise to tighten.
c. Push down on the tabs (so they lay flat against the sides of the marker.
d. Slide the protective boot up, onto the cartridge.
Ensure the boot is positioned above the tabs on the cartridge.