Telesis PINSTAMP TMP4100 Series, Установка и обслуживание, Страница: 17 / 62

TMP4100-Series Installation/Maintenance
33480D01.DOC
1-7
1.4.1 General
•
TMP4150, TMP4155:
A safety guard may be required to keep operators away from the moving marking
head and impact pin.
•
TMP4150, TMP4155:
A part-present switch may be installed to allow a
START PRINT
only when a part is
in marking position.
•
Operators may need hearing protection depending on distance from the marker and the part to be marked.
•
Operators may need eye protection while operating the marker.
1.4.2 Environmental Considerations
•
TMP4100, TMP4100E:
The marker should not be exposed to sprays, solvents, chemicals, or other
contaminants.
•
TMP4150, TMP4155:
These markers may be exposed to light sprays, solvents, chemicals, or other
contaminants.
•
Do not operate the marker in an area where flammable mists or fumes are present.
•
Certain chemicals may damage the exposed portion of the cartridge.
1.4.3 Marking Head
•
The marking head should be visible from the controller. The standard marker cable is 4 m (13 ft.) long.
•
TMP4150, TMP4155:
Provisions should be made to allow vertical adjustments to the marking head,
allowing the marker to be positioned closer to and further away from the part being marked.
•
TMP4150, TMP4155:
Provisions should be made to allow horizontal and lateral adjustments to the
marking head, allowing the marker to be positioned along both the X-axis and the Y-axis.
•
TMP4150, TMP4155:
The marking head can be plumbed to receive internal air pressure. Positive air
pressure within the marker will help prevent contaminants from entering the marking head cavity.
Never exceed an internal air pressure of 2.0 psi (0.13 bars) within the marking head.
•
The part to be marked must be solidly fixed into position.
•
The marker must be solidly secured (or held) and must not move in relation to the part while marking.
1.4.4 Filter/Regulator Unit
TMP4100E:
The TMP4100E does not use air pressure to drive the marking pin. The following section does
not apply to the TMP4100E marker.
TMP4100, TMP4150, TMP4155:
The filter/regulator unit inlet receives air pressure from the plant air source.
The drive air outlet supplies air pressure to the marker to drive the marking pin out of the pin cartridge for
marking. Return air pressure retracts, and holds, the pin in the cartridge. For TMP4100 markers, the marking
head contains an internal regulator to control the return air. For TMP4150 and TMP4155 markers, the return
air is controlled by a separate regulator on the filter/regulator unit.
•
The filter unit should be installed within 12 ft. (3.6 m) of the marking head; 50 ft. (15 m) maximum.
•
A pneumatic lockout valve (supplied by the customer) should be installed upstream of the filter unit.
•
A pressure relief valve (supplied by the customer) should be installed upstream of the filter unit.
•
The pressure relief valve must be set to a maximum pressure of 120 psi (8.3 bars).
•
Do not connect the filter unit to air systems where compressors are lubricated with fire resistant fluids
such as phosphate ester and di-ester types.