Telemotive Engineered XLTX Transmitter Instruction Manual
May 2011
Page 22 of 40
5.0
OPTIONAL PROGRAMMING WITH RCP
Using the optional RCP software makes programming of the XLTX easier and allows for settings
to be saved for future reference.
WARNING
THE USE OF RCP (RADIO CONTROL PROGRAMMER) IS INTENDED FOR USE BY
AUTHORIZED PERSONS ONLY. CHANGES TO ANY RADIO DATA VALUE MAY LEAD TO
UNEXPECTED, UNDESIREABLE, OR UNSAFE OPERATION OF EQUIPMENT AND
FURTHERMORE MAY LEAD TO EQUIPMENT DAMAGE, PERSONAL INJURY, OR EVEN
DEATH. ALL EQUIPMENT OPERATORS AND/OR PERSONNEL SHOULD BE NOTIFIED OF
ANY RADIO DATA VALUE CHANGES THAT MAY AFFECT OPERATION.
5.1 ACCESS
CODES
The receiver and transmitter must be programmed with the same access code to properly
communicate with each other.
WARNING
TWO OPERATIONAL TRANSMITTERS WITH THE SAME ACCESS CODES OPERATING AT
THE SAME TIME IS A DEFINITE SAFETY HAZARD. FAILURE TO FOLLOW THIS WARNING
COULD RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO EQUIPMENT.
5.2
CHANGING RECIEVER ACCESS CODES
Receiver Access Code Programming.
For detailed instructions on setting parameters including
access codes, see the “Programming” section of the applicable receiver manual.
WARNING
AFTER CHANGING THE ACCESS CODES ON THE TRANSMITTER, TEST THE UNIT BY
TURNING IT ON AND OFF NEAR THE APPROPRIATE RECEIVER. IF THE RECEIVER DOES
NOT RESPOND, DO NOT ACTIVATE A FUNCTION BUTTON! THE TRANSMITTER MAY HAVE
THE WRONG ACCESS CODE, WHICH COULD MOVE OTHER EQUIPMENT. RE-CHECK THE
ACCESS CODE IN THE TRANSMITTER AND RETEST. FAILURE TO FOLLOW THIS
WARNING COULD RESULT IN SERIOUS INJURY OR DEATH, AND DAMAGE TO
EQUIPMENT.
