Appendix E –10K JLTX Transmitter (Continued)
E-5. Batteries.
Two batteries are available, a disposable alkaline
battery BT107-0 and a rechargeable NiMH
BT108-0. The single unit charger for the BT108-
0 is E10674-0. Please follow local regulations
for the disposal of any battery product.
The “LOW BATT” red LED will flash briefly
just before transmitter shuts down due to low
battery. If this light flashes, then replace the
battery immediately. The flashing red “BATT
MONITOR” LED flashes rapidly during
transmit, slowly when unit is ON and turns out
when battery is low.
E-6. Intrinsically Safe.
Certain models of the JLTX are intrinsically safe
and these are clearly marked so on the bottom of
the case. To maintain the intrinsically safe rating
an intrinsically safe battery must be used.
Intrinsically safe batteries are labeled
intrinsically safe. Connect your Telemotive
representative for the part number of the
intrinsically safe battery for your transmitter.
WARNING
FOR INTRINSICALLY SAFE PRODUCTS
ONLY QUALIFIED TRAINED SERVICE
PERSONNEL ARE ALLOWED TO PERFORM
REPAIRS. FAILURE TO USE APPROVED
SERVICING TECHNIQUES AS WELL AS
TELEMOTIVE APPROVED PARTS FOR
INTRINSICALLY SAFE PRODUCTS COULD
CREATE A SAFETY HAZARD. IF THERE IS
ANY QUESTION AS TO WHOM IS
QUALIFIED, WHAT PARTS TO USE OR
PROPER SERVICE PROCEDURES PLEASE
CONTACT YOUR TELEMOTIVE
REPRESENTATIVE. FAILURE TO FOLLOW
THIS WARNING COULD RESULT IN
SERIOUS INJURY OR DEATH AND
DAMAGE TO EQUIPMENT.
E-7. Replacement Parts.
The following pictures on pages E-7, through E-
9 detail replacement parts for the JLTX.
WARNING
FOR PRODUCT MODELS LISTED IN
COMPLIANCE WITH UL, CSA AND ANSI
INTRINSICALLY SAFE STANDARDS, DO
NOT ATTEMPT TO REPAIR WITHOUT
USING TELEMOTIVE APPROVED
REPLACEMENT PARTS. FAILURE TO DO
SO COULD VOID LISTING AND CREATE A
SAFETY HAZARD. FAILURE TO FOLLOW
THIS WARNING COULD RESULT IN
SERIOUS INJURY OR DEATH AND
DAMAGE TO EQUIPMENT.
E-8. Joystick and Levers.
Please note should the lever and joysticks need
servicing, please contact Telemotive.. These are
environmentally sealed switches, tested for
millions of cycles and should not need
replacement under normal conditions.
WARNING
DISASSEMBLING THE JOYSTICK OR THE
LEVER WITHOUT PROPER TRAINING AND
EQUIPMENT COULD DESTROY THE SEAL
AND DAMAGE THE SWITCH CAUSING
IMPROPER OPERATION. FAILURE TO
FOLLOW THIS WARNING COULD RESULT
IN SERIOUS INJURY OR DEATH AND
DAMAGE TO EQUIPMENT.
E-9. JLTX Transmitter Firmware.
EPROMs are not used in the JLTX Transmitter
Board Rev. F and higher; firmware (software) is
stored internally in non-volatile flash memory.
Software updates are done in the factory through
the firmware loading connector. A firmware
version label on the board indicates the software
version loaded into flash memory.
.
E-6
