Appendix E –10K JLTX Transmitter (Continued)
WARNING
BEFORE OPERATING THE TRANSMITTER FAMILIARIZE YOURSELF WITH ALL SAFETY
INFORMATION IN THIS MANUAL, THE CORRESPONDING 10K SYSTEM MANUAL
(TC10KMOD-0), APPROPRIATE MANUAL SUPPLEMENTS AND ANY OTHER LOCAL, STATE,
OR FEDERAL RULES OR REGULATIONS ALREADY IN EXISTENCE. FAILURE TO FOLLOW
THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO
EQUIPMENT.
E-1. JLTX Transmitter Operation.
Sections E-1.1. through E-1.10. describe the
functional operation of the JLTX. Please refer to
Figure E-1. Typical 10K JLTX Control Layout
for control location.
E-1.2. Key Switch. (For Models So Equipped,
disables power to transmitter circuitry only).
For models so equipped, turning the key off and
removing it will disable the transmitter. Turning
the key switch to on enables power to the
transmitter unit, but does not activate the
transmitter controls or turn on the receiver. The
ON/OFF pushbutton must be pushed to turn the
transmitter and receiver on or off. Under normal
procedures it is recommended that the unit be
turned off with the ON/OFF pushbutton before
turning off the key switch. If the key switch is
Joy Stick
Lever
turned off with the transmitter and receiver on,
the key switch must be turned on again to use the
ON/OFF pushbutton or E-STOP.
NOTE
FOR UNITS EQUIPPED WIT A KEY
SWITCH. THE KEY IS TO BE USED FOR
RENDERING THE TRANSMITTER
DISABLED ONLY; IT DOES CONTROL THE
RECEIVER OR POWER TO OR FROM THE
RECEIVER.
E-1.3.
“ON-OFF” Push-Button (Turns
transmitter and receiver on and off).
(With the key switch engaged, for units with a
key switch), pressing the ON/OFF push-button
switch turns the transmitter and the receiver on.
If the transmitter is on the BATT MONITOR
H2
H1 B
AUX 1
AUX 3
SEL.
LOW
BATT
BATT
MONITOR
E. STOP
ON-OFF
AUX 2
AUX 4
Figure E-1. Typical 10K JLTX Control Layout
E-1
