SWITCH SETTINGS
There are installer selectable switches located on the bottom base underneath a protective plastic overlay. These switches are
hidden behind a plastic cover for security. To locate, remove the plastic covers using a sharp pointer or paper clip as shown.
Message Waiting Selector
The 2802MWD can support 90VDC neon or low-voltage LED message waiting
systems. Simply slide the switch to the desired position that is compatible with
your PBX messaging system.
Note: the phone is factory preset to the “Neon” setting.
4
Line Voltage Selectors
The 2802MWD is designed to operate behind PBX telephone systems rated
between 24 volts and 48 volts. There are line voltage selector switches that
must be set according to the PBX system rating that the phone will be installed.
There are two (2) switches, the first for Line 1 and the other for Line 2. Each
switch has three (3) setting options. They are: “24V/48V/OFF”. Set the
switches by simply sliding to the appropriate setting. The ”OFF” setting is used
to turn off the line if a line appearance is not wired to the telephone. (figure 6)
Note: the factory default is set to the “24V” setting.
LED
24V
L2
L1
NEON
48V
OFF
Figure 6
Figure 5
LED
24V
L 2
L 1
NEON
48V
OFF
