8
www.telematrix.net
TRIMLINE SERIES USER GUIDE
telephone lines, and internal metallic water pipe system,
if present, are connected together. This precaution may
be particularly important in rural areas.
Caution: Users should not attempt to make such
connections themselves, but should contact
the appropriate electric inspection authority, or
electrician, as appropriate.
Notice: The Ringer Equivalence Number (REN)
assigned to each terminal device provides an
indication of the maximum number of terminals
allowed to be connected to a telephone interface.
The termination on an interface may consist of
any combination of devices subject only to the
requirement that the sum of the Ringer Equivalence
Numbers of all the devices does not exceed 5.
REN: Z
For warranty and service in Canada, please contact:
Williams Telecommunications
5610 Kennedy Road
Mississauga, Ontario, L4Z2A9
Canada
Phone: 905-712-4242
Fax: 905-712-1754
Requirements of Part 15—
FCC Rules
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
FCC RF Radiation Exposure
Statement
The installation of the base unit should allow
at least 20 centimeters between the base and
persons to be in compliance with FCC RF exposure
guidelines. For body-worn operation, the portable
part (handset) has been tested and meets FCC RF
exposure guidelines.
This device must not be co-located or operating in
conjunction with any other antenna or transmitter.
The changes or modifications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the equipment.
Industry of Canada Requirements
Note: This equipment meets the applicable
Industry Canada Terminal Equipment Technical
Specifications. This is confirmed by the registration
number. The abbreviation, IC, before the registration
number signifies that registration was performed
based on a Declaration of Conformity indicating
that Industry Canada technical specifications
were met. It does not imply that Industry Canada
approved the equipment.
Before installing this equipment, users should
ensure that it is permissible to be connected to
the facilities of the local telecommunications
company. The equipment must also be installed
using an acceptable method of connection. The
customer should be aware that compliance with
the above conditions may not prevent degradation
of service in some situations.
Repairs to certified equipment should be
coordinated by a representative designated by the
supplier. Any repairs or alterations made by a user
to this equipment, or equipment malfunctions, may
give the telephone communications company cause
to request the user to disconnect the equipment.
Users should ensure for their own protection, that
the electrical ground connections of the power utility,
Содержание 1L Trimline
Страница 1: ...TRIMLINE SERIES USER GUIDE 1L Trimline...
