TRIMLINE SERIES USER GUIDE
www.telematrix.net
5
Operation
CALLING
PLACING A CALL USING THE HANDSET
• Lift the handset (off-hook position).
• Dial out by using the numeric dial pad.
RECEIVING A CALL USING THE HANDSET
• Lift the handset when ringing.
Service
Cetis, Inc., is the manufacturer of Scitec, Teledex,
and TeleMatrix brand guest room telephones.
When problems arise that cannot be resolved
using this or related documents, please go to
www.telematrix.net/support for information about
customer support, technical support, warranty,
and product returns.
Statement of Limited Warranty
TELEMATRIX, INC. warrants to its [original
end customer] [purchaser] that Spectrum
PLUS, Marquis and RETRO branded products
manufactured by
TELEMATRIX, INC. are free
from defects in materials and workmanship for
five (5) years after the date of purchase, products
manufactured by TELEMATRIX, INC. are free from
defects in materials and workmanship for three
(3) years, other than the following products for
which the warranty period shall be one (1) year:
handset batteries, either NiCd or NiMH, used in
TELEMATRIX, INC. cordless products. If a product
fails this warranty during the warranty period,
TELEMATRIX, INC. will, at its option, either repair
or replace the defective product or parts, or
deliver replacements for defective products or
parts on an exchange basis at no additional charge
to the customer except as set forth below. Repair
parts or replacement products may be either new
or reconditioned. Products or parts returned to
TELEMATRIX, INC. under this warranty will become
Once aligned, slide the base unit onto the studs
and snap the base unit into place.
SECURE MOUNTING OPTION
The TeleMatrix Trimline base unit can be
permanently attached to the wall using screws.
This mounting option is ideal for areas requiring
security. Underneath the index card are 2 mounting
holes. To locate, remove the clear plastic overlay
and the paper index.
Switch Settings
TONE/PULSE SWITCH
The Tone/Pulse switch is located underneath a
cover plate located on the handset. Use a sharp
pointer to remove the switch cover plate to expose
the switch.
Set the switch to the proper dialing mode that is
compatible to your line service. If your lines are
equipped with touch-tone service, set the switch
to the Tone position. If you do not have touch-tone
service, set the switch to the pulse position. The Pulse
setting will electronically simulate rotary dialing.
MESSAGE WAITING SWITCH
This telephone is standard equipped to support
eight high-voltage (90VDC Neon) or low-voltage
(LED) message-waiting systems. A selector switch
is provided underneath the faceplate for security.
The options are:
NEON = 90 VDC NEON
LED = LOW VOLTAGE
Note: The switch is factory set to the Neon position.
RINGER VOLUME CONTROL SWITCH
There is a slide switch located on the right side of
the base unit that is used to adjust the loudness
of the ringing sound. A low and high setting are
provided. Select the desired loudness by sliding
the switch in the appropriate position.
Содержание 1L Trimline
Страница 1: ...TRIMLINE SERIES USER GUIDE 1L Trimline...
