Telefunken TF-LED32S13, Инструкция по эксплуатации

Страница: 10 / 31

Operation
10
8
Operation
Changing the battery
1. Remove the battery compartment cover
on the back of the RC.
2. Insert two AAA batteries into the battery
compartment making sure that the correct
polarity is observed.
3. Put the cover back.
• The RC should be pointed at remote
sensor within 8 meters and within 30 degrees
at the left or the right side.
• Take the battery out of the RC if it is not
used for a long time.
• Do not mix new and used batteries or
different types of batteries. Weak batteries can
leak and severely damage the RC.
• Do not expose the RC to shock, liquids,
and do not place it in an area with high
humidity.
General operations
• Press POWER button on the unit or on
the RC to switch on the power, the indication
on the unit will light up. Press POWER button
again to switch off the power, and the light will
be in red color.
• Press VOL- button repeatedly to decrease
the volume; press VOL+ button repeatedly to
increase the volume.
• Press RETURN button on the RC to select
from the present channel and the previously
displayed channel.
• Press MUTE button to cut off sound, press
this button again or adjust volume to resume
sound.
• Press PR-/PR+ buttons to select previous
or next channels; or press number buttons to
enter a channel number directly.
• Press P.M. button repeatedly to cycle
through the available video picture modes
from the following types: Normal => Soft =>
Personal => Bright.
• Press S.M. button repeatedly to cycle
through the available sound modes from the
following types: Standard => Music => Film =>
News => Personal.
Press NICAM button in TV mode repeatedly
to switch between Stereo, Mono, Dual I,
Dual I+II and Dual II sound modes (can be
unavailable for some channels).
• Press FREEZE button to freeze the picture
on or off.
• Press FAV. button to show the favourite
channel list. Press UP/DOWN to select next or
previous favorite channel. Press OK to confirm.
Signal sources
Press SOURCE button, then press DOWN/
UP cursor buttons on the RC or PR UP/PR
DOWN buttons on the panel to select a source
from available source list: TV(AIR) - DTV - AV
- YPBPR - HDMI1 - HDMI2(MHL) - HDMI3 -
PC - USB. Press ENTER button on the RC or
STANDBY button on the panel to confirm.
TELETEXT operations (option)
• Select the TV source mode. Then press
PR-/PR+ buttons to select TV channel in order
to pick up the picture signal of Teletext.
• Press PR-/PR+ buttons to select the
previous page or the next page.
• Teletext button functions are as follows:
HOLD: Press this button to stop the move
to the next page. Press this button again to
cancel operation.
INDEX: Press this button to go to the index
page.
CANCEL: Press this button to cancel the
teletext; press again to show the teletext.
REVEAL: Press this button to reveal the
concealed information. Press this button again
to conceal the information.
SUBPAGE: Press this button to select sub
page, then press Red/Green buttons to select
the desired subpage.
MIX: Press this button to mix the teletext
and current TV signal image (transparent
background).
RED/GREEN/YELLOW/BLUE buttons:
Press these 4 color buttons to access directly
to corresponding color page displayed at the
lower parts of teletext screen.