Telefunken TF-JS04, Инструкция по эксплуатации

Страница: 5 / 16

Instruction manual
5
In the event of a short circuit, the fuse will
blow to prevent possible fire. In this case,
immediately discontinue use of the device and
contact an authorized service center for
repair.
After starting the engine, disconnect the
device, remove the plug from the input socket,
disconnect the connection clip from the
battery.
Operating as a backup power
source
Besides its main purpose, the device can be
used to power most portable electronics -
laptops, telephones, photo and video
cameras, etc. We draw your attention to the
fact that different devices consume different
voltages (for example, laptops are often 19 V).
Carefully study the characteristics of your
portable device and make sure that you have
correctly selected the voltage before
connecting to the battery.
Laptop charging
Select the adapter for the laptop from
the included set.
Connect the laptop charger cable to the
device.
You can use the laptop while charging.
Charging other portable
devices via USB port
Connect using a USB cable.
Turn on the device.
When the portable device is charged,
remove the plug first from the jump
starter, then from the portable
electronic device.
LED flashlight
To turn on the LED flashlight, press and
hold the power button for 3 seconds. The
flashlight has several modes of operation:
Normal / Flashing / SOS. Press the power
button to change the mode.
Press and
hold this button in any mode to switch the
flashlight off.
Solar battery
This unit is equipped with a built-in 3-
section solar panel. Position the unit with
the panel under the sun light to charge it
automatically.
Also, you can connect an additional solar
battery to this unit using the
charging input
on the side panel.
Qi wireless charging
The top panel of the unit is equipped with
a Qi wireless charging panel. If your
mobile device supports the Qi charging
feature, you can place it on the panel to
charge it.
Compressor
This unit is supplied with a miniature
compressor for inflating wheel tires, balls,
airbag beds and other uses of compressed
air.
Connect the compressor jack and the
object you want to inflate using the
compressor hose.
Press the
on/off button on the compressor
to start pumping compressed air.
Monitor the pressure using a pressure
gauge integrated in the compressor.
Follow the manufacturer's
recommendations for pressure selection.