Telefire
ADR-3000 – System Introduction
Revision 1.10 4 November 2004
5 Software and Tools
5.1 TCS-3040 Programming and Control Software for the ADR-3000
The TCS-3040 (Telefire Control Software) is a powerful interface tool that enables the
monitoring of the control panel and performing general tasks such as remote project
programming from the PC.
The TCS-3040 can use the PC’s modem to connect remotely via a phone line to the
ADR-3000 via the optional MCID-34 modem.
If the ADR-3000 is equipped with Telefire’s NET-3000 module, the TCS-3040 can
perform the same function over TCP/IP via the organization’s intranet or over the
Internet if such a connection exists. The TCS-3040 should be version 3.20 or higher to
support TCP/IP connection.
Please refer to the TCS-3040 manual for further information.
5.2 MCS-3000 Centralized Fire Alarm Systems Monitoring Software
Telefire's MCS-3000 Centralized Fire Alarm Systems Monitoring Software is a Microsoft
Windows™-based program that monitors fire alarm systems equipped with the
NET-3000 Internet Enabled Monitoring and Notification Module. The NET-3000 can be
installed in Telefire's ADR-3000 Analog Addressable Fire Alarm Control Panel and
GSA-1000 Multi-Zone Conventional Fire Alarm Control Panel.
The MCS-3000 constantly scans over the LAN / WAN all configured panels, allowing the
monitoring of multiple fire alarm control panels, using a single screen that concentrates
the whole systems status including normal operation, alarm and trouble.
For security reasons the MCS-3000 does not allow remote control (activations) of fire
alarm control panels.
A single screen can display system summary of a large number of systems. Clicking on
any of the systems will open a browser window that will display the web page for that
system.
Please refer to the MCS-3000 manual for further information.
5.3 PROG-4000 Analog Addressable Detector and Accessory Programmer
The PROG-4000 is a tool for programming and testing all of Telefire’s analog
addressable devices such as detectors, manual fire alarm call points, input modules,
output modules, remote power-supplies, etc.
Each addressable device connected to the ADR-3000 system can be programmed to an
address in the range of 1 to 127. This address will be stored in the device’s permanent
memory and can be changed only with the PROG-4000 programmer.
Some input and output modules use more than one address. For these modules, the
programmer will store the first of several consecutive addresses in the module.
In addition to programming device addresses, the PROG-4000 serves as a testing unit
for all addressable devices. These tests include verification of features, and conditions
of the tested device such as normal operation, alarm, various trouble conditions, etc.
The PROG-4000 includes an alphanumeric display, keyboard, analog detector base and
a connector with programming cord, to program addressable modules. An add-on
conventional base is used with the programming cord to program the TIP-224A Analog
Addressable Notification Sounder.
Please refer to the PROG-4000 technical manual for further details.
– Page 22 –
