Teledyne ProEM Series, Системное руководство

Страница: 47 / 162

Chapter 4 System Setup 47
4.9 Entering the Default Camera System Parameters
4.9.1 WinX/32 Versions 2.5.25 and later
1. Make sure the ProEM is connected to the host computer and that it is turned on.
2. Run the WinX/32 application. The Camera Detection wizard will automatically run if
this is the first time you have installed a Teledyne Princeton Instruments WinX
application (WinView/32, WinSpec/32, or WinXTest/32) and a supported camera.
Otherwise, if you installing a new camera type, click on the Launch Camera
Detection Wizard… button on the Controller/CCD tab to start the wizard.
3. On the Welcome dialog leave the check box unselected and click on Next. See
Figure 4-9 .
Figure 4-9: Typical WinX/32 Camera Detection Wizard - Welcome Dialog
4. Follow the instructions on the dialogs to perform the initial hardware setup: this
wizard enters default parameters on the Hardware Setup dialog tabs and gives you
an opportunity to acquire a single test image to confirm the system is working. Note
that this is a test image and it is not acquired using the settings needed for true data
acquisition.
5. To finalize the setup, make the following selections on the Controller/Camera tab
so you can control the camera and acquire data at the default Detector
Temperature setting:
•
On the Controller/Camera tab: Make sure Frame Transfer is selected as the
Readout Mode. See
Figure 4-10 .
4
4
11
-01
26
_
0024