WaveSurfer 4000HD Rackmount Accessory
1.
Using the T10 Torx driver, remove the feet from the oscilloscope.
2.
Attach the side plates to the base plate using six M4x10 Phillips screws.
Note: The left- and right-side plates are not interchangeable. Be sure the “wings”
are on the side of the base plate without the lip, turning outward, as shown.
2
Assembly Instructions
3.
Attach the handles to the face plate using the four M5x10 Phillips screws, then
attach the face plate to the side plates using eight M4x10 Phillips screws.
Note: Be sure the thinner rib of the face plate is on top, as shown below.
4.
Place the oscilloscope on the base plate flush with the face plate. The screen
should be fully visible and the front bezel should extend slightly past the face
plate when seated properly.
3
