4
www.teledex.com
M SERIES ANALOG CORDED USER GUIDE
ADJUSTING THE RING VOLUME FOR BASE
The up and down volume keys will adjust the
ringer volume of the telephone . The M Series
telephone begins at the lowest setting, then
automatically rings louder with each successive
ring during an incoming call .
The speakerphone has five (5) levels . To adjust
ring volume, locate the volume up/down keys,
located on the front surface of the phone to the
right of the keypad .
ADJUSTING SPEAKERPHONE VOLUME
The speakerphone has five (5) levels . To adjust
speakerphone volume, locate the volume up/
down keys, located on the front surface of the
phone right of the keypad .
ADJUSTING HANDSET RECEIVER VOLUME
The handset has five (5) volume levels . To adjust
the handset volume, locate the volume up/down
keys . Pressing the down key will decrease the
volume level, while pressing the up key will
increase it .
REDIAL
The M Series can automatically redial the last
number dialed . Lift the handset or turn on the
speaker phone then press the
REDIAL key to
redial the last number .
USING THE HOLD KEY
The
HOLD key places the call on hold locally at
the M Series telephone .
With a call active, press the
HOLD key on either
line to remove a call from hold:
1 . Press the line key of the call on hold . This
will remove the call from hold, making the
call active again .
2 . The red LED will return to blinking
illumination, indicating the line is active .
To change phones after placing a call on hold:
1 . Place the call on hold as above .
2 . Pick up the call at another telephone that
is on the same line . The telephone will
activate the line and remove the hold at
the original telephone .
TO MUTE THE SPEAKERPHONE
1 . Press the
MUTE key on the base unit .
The red LED above the
MUTE key will
illuminate . The party on the other end will
not be able to hear you when the
MUTE
LED is lit .
2 . Press the
MUTE key again to turn off the
mute feature . The
MUTE LED will go out .
AUTO-DIAL KEYS—FACEPLATE OFF
The M Series has either five (5) or ten (10)
programmable guest service (auto-dial) keys,
depending on the model you own .
These keys can be programmed to automatically
dial telephone numbers, or to activate telephone
system features . To program the auto-dial keys
(programming can only be done from base unit):
1 . With the phone on hook (inactive) and
the fixed faceplate removed, press the
recessed
STORE key .
2 . Enter the desired telephone number (up to
32 digits in length) to be stored . To enter
a pause in the number string, press the
REDIAL key as necessary .
3 . Press the
STORE key again .
4 . Press the auto-dial key where the number
is to be stored . Programming is now
completed for that auto dial key .
To program additional keys, repeat this process .
CONFERENCE (2-LINE MODELS ONLY)
The
CONF key allows for three-way conversations .
Depending on the situation, you may initiate a
conference call using one of these methods:
