© Telect, Inc. All rights reserved. 148326 09.08.16 v2
1.509.926.6000 :: telect.com
14
LTX Patch and Splice Panel
LTX Patch and Splice Panel
Fiber :: Install guide
3.1.9 Install Panel Doors
Refer to
Figure 3-9
for this procedure.
Spring-hinged doors mount to the front and rear bottom edges of the
LTX panel.
1.
On the LTX panel locate the two round mounting pin holders
along the front bottom edge.
2.
Position the door fl at along the edge of the panel bottom.
3.
Press the door edge toward the panel bottom edge while sliding
the hinge pins out toward the sides.
4.
Slowly release the two hinge pins into the mounting pin holders
on the bottom edge of the LTX panel so that they are inserted
into the slots.
5.
Pull the door up to the closed position to ensure that spring
hinges operate correctly.
6.
Repeat Steps 1 - 5 to install the other door.
Latch doors in the closed position by pressing down on the
center door latch while pushing the door in. Release the latch
so that the tab catches in the slot at the top of the LTX panel. To
open, press down on the door latch to release the tab and swing
the door down.
Figure 3-9 - Door Installation
3.1.8 Install Adapter Patch Plate
Refer to
Figure 3-8
for this procedure.
The Adapter Patch Plate installs at the front of the LTX Patch and
Splice Panel. The patch plate comes with adapters pre-installed.
Pigtail fi bers from the splice tray willl connect to connectors at the
rear and fi ber jumpers will connect to adapters at the front of the
patch plate.
1.
Position the patch plate at the front of the LTX patch and splice
panel with fi ber jumper adapters facing toward the front of the
LTX panel and pigtail connectors facing the rear of the LTX
panel.
2.
On one side of the LTX panel, align top and bottom screw holes
with patch plate screw holes.
3.
From the outside of the LTX panel, insert screws and hand
tighten.
4.
On the other side of the LTX panel, align top and bottom screw
holes with patch plate screw holes.
5.
From the outside of the LTX Panel, insert screws and hand
tighten.
6.
Ensure patch plate is centered and there is a little clearance
around the plate and the panel.
7.
Use a Phllips screwdriver to tighten all four screws.
Figure 3-8 - Adapter Patch Plate Installation
Adapter Patch Plate
(144 SC Terminations
shown)
Screws
Screws
Some clearance between
Patch Plate and LTX Panel
LTX Panel
Front View
Round Mounting
Pin Holders
Bottom
(of panel)
Door
Door
Hinge
Door
Hinge
Door Latch
Tab
Door Latch Slot
(on top of panel)
LTX Panel
