Telecom Behnke 20-0040-IP, Руководство пользователя

Страница: 32 / 72

32 www.behnke-online.com
GB
Configuration and Set-up
GB
Additional SIP door bell / SIP PA system connection
▸ Connection via SIP intercom station with
10/100 Mbit Ethernet LAN
▸ Power supply via Power over Ethernet (PoE
according to IEEE 802.3af)
By default, Behnke SIP electronics come pre-set
to automatic IP configuration via DHCP. It will
automatically obtain its IP address from a DHCP
server, where available. Otherwise, cf. page
29 or 39.
2.1.2. 20-0040A-IP
RJ45 connection socket (LAN) (from the switch,
POE class 0 power supply)
Level adjustment for PA system connection
(adjustable with 0.4x2 slotted screwdriver)
speakON socket for connection to PA system
(LF audio output) and for contacting the relay
(potential-free normally open contact)
Wall mounting bracket (mounting material (dowels/
screws) included in the box, mounting bracket is
folded in transport mode (rear of housing)
Compatible plug (included in the box):
Neutrik speakON NL4FX / NL4FC
Please see the open plug for the plug assignment
(cover cap removed through strain relief)
Caution: For wiring, cf. page 36 of this manual or
the label next to the plug on the housing
After the power supply has been established, it
takes about 90 seconds for the door intercom
station to automatically start to announce its IP
address. Once you have heard this signal, your
intercom station is available.
Caution: When you connect your SIP door inter-
com station to a new network, it may take up to
5 minutes before the device will obtain a new IP
address from the DHCP server.
1-
1+
2+
2-