Tele Radio TG-R4-1, Руководство по установке

Страница: 50 / 86

START THE TRANSMITTER IN OPERATING MODE USING RFID
NOTE! The transmitters will only accept RFID tags from Tele Radio AB.
1. Make sure that the stop button is pressed.
2. Twist and pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
3. WITHIN 10 SECONDS: Press the RFID tag against the RFID antenna above the stop button on the
front of the transmitter. The buzzer beeps 2 times to confirm that an RFID tag has been shown. The top
LED lights (green when the battery capacity is good, red when the battery capacity is poor).
4. WITHIN 3 MINUTES FROM PULLING OUT THE STOP BUTTON:
Press a button to select the receiver(s) that you want to operate.
The receiver(s) that was selected in the last session will be automatically selected, which is indicated by
the corresponding LED(s) that light red. If no receiver(s) has been selected, the LEDs for all available
receivers will flash red. If a receiver is selected, the LEDs next to the left and the right start buttons flash
red. If no receiver(s) are selected, only the LED next to the right start button flashes red.
5. Press both start buttons at the same time.
The buzzer beeps.
6. Release the start buttons.
The buzzer stops beeping. The top LED flashes (green when the battery capacity is good, red when the
battery capacity is poor).
7. When radio communication has been established and the RFID tag has been accepted, LED 1 lights
(green when the battery capacity is good, red when the battery capacity is poor).
If radio communication is not established within 25 seconds, the transmitter turns off. If the RFID tag is
not accepted, the display shows an error message.
TURN THE TRANSMITTER OFF
1. Press the stop button. The transmitter turns off. All relays deactivate.
LOGIN/LOGOUT
NOTE! When the transmitter has established radio communication with one or more receivers, you
can make a Quick logout from those receivers. Note that the Quick logout will log the transmitter out
from all receivers that are participating in the session.
NOTE! If you need to log out a transmitter that is lost or damaged, it is possible to log out from the
receiver. We do not recommend this way of logging out. Contact your representative for assistance.
- 50 -