Tele Radio TG-R4-1, Руководство по установке

Страница: 4 / 86

WARNINGS & RESTRICTIONS
WARNING! Tele Radio remote controls are often built into wider applications. We recommend that
the system is provided with a wired emergency stop where necessary.
NOTE! We recommend that the functionality of the STOP button is being tested at a regular basis: At a
minimum, when used for 200 hours. To test the STOP button: press, twist and pull it out.
INSTALLING, CONNECTING AND MOUNTING
n
Allow only licensed or qualified personnel to install the product.
n
Switch the power supply off to the receiver before connecting the equipment.
n
Check that you have connected the power supply to the correct connection terminal.
n
To utilize the safety of the system, use the stop relays in the safety circuitry of the object that you
want to control.
n
Use undamaged cables. No cables should hang loose.
n
Avoid installing in areas affected by strong vibrations.
n
Place the receiver well away from wind, damp and water.
n
Cable glands and vent plugs must face down to prevent water from seeping in.
THE USER
n
Make sure that the user is following the instructions.
n
Make sure that the user has reached the certified age of your country to operate the equipment.
n
Make sure that the user is not under the influence of drugs, alcohol and medicines.
n
Allow only qualified personnel to have access to the transmitter and operate the equipment.
n
Make sure that the user does not leave the transmitter unsupervised.
n
Make sure that the user always turns the transmitter off when not in use.
n
Make sure that the user keeps a good overview of the work area.
MAINTENANCE
n
Use the stop button to start and turn off the transmitter as often as possible.
n
When error messages are shown, it is very important to find out what caused them.
n
If the stop button is mechanically damaged, contact your representative for service immediately.
n
Always contact your representative for service and maintenance work on the product.
n
Write down the serial numbers/ ID codes of the receivers and transmitters used. This inform-
ation should be recorded on the “Settings document” for your product (download from our web-
site).
n
Avoid registering transmitters to receivers where it is not being used.
n
Keep the safety instruction for future reference. Always download the configurations instruction
from our web site for the latest version available.
- 4 -