3.6 RST Button
The different RST button features are described below.
Fig. 9:
RST button
3.6.1 Rebooting the device
Once the device is operating normally, pressing the RST button will force a restart.
Note
It will also force a restart of the embedded access point (if present).
3.6.2 Default Configuration
The RST button allows you to boot the device with its default configuration (including the embedded access point, if
present). To do so, follow these steps:
• With the device switched off, press and hold the RST button down while you turn the router on using the ON/OFF
switch (1).
• The PWR LED (green) will light up and LED 'S' will begin to blink (amber). It will carry on blinking for 10 seconds.
• To boot the device with the default configuration, release the RST button while LED 'S' is still blinking (i.e. before
the 10-second period expires).
The router has an embedded access point. The default configuration looks like a template for a Wi-Fi configuration. It
includes all the necessary elements to deploy a very basic Wi-Fi network. To activate this configuration, all you need
to do is to enter the
enable
command at the WNMS feature menu.
This configuration will provide two Wi-Fi networks:
test_ssid_1
and
test_ssid_2
. The first one is placed in the 2.4 GHz
band and the second one in the 5 GHz band. The password for both networks matches their ssid name.
The DHCP server configuration is divided into two parts. The first one focuses on giving an address to the embedded
access point, while the second strives to give an address to the Wi-Fi clients that connect to the access point.
A bridge is installed to separate the traffic belonging to Wi-Fi clients from access point communications. Two VLANs
are configured for this purpose.
The communication with the embedded access point is carried out via a separate port in the switch interface. This
port is named "wlan" or listed as port 5.
The router's default configuration establishes the following access IP and mask address:
• IP address: 192.168.0.1
• IP mask: 255.255.255.0
The embedded access point's default configuration establishes the following IP and mask address:
• IP address: DHCP client with no. 192.168.100.150/24 as default
Note
Some devices leave the factory with customized settings. This personalization means your router's de-
fault configuration (and that of the embedded access point, where applicable) may be different from the
one shown above.
Teldat S.A.
3 Components and Power Supply
Teldat Connect-KFPlus
13
