3.4.2 Restoring the factory default settings
Complete the following steps to reset the device with its factory default settings:
(1)
Press the RST button. Three LEDs (S, C and L) on the front panel light up in amber to indicate that the device is
in reset mode.
(2)
Keep pressing the RST button. The S LED flashes green while you are pressing the RST button. This state im-
plies that the factory default settings have been restored.
(3)
Stop pressing the RST button so that the device can restart.
(4)
The device will restart with the S and C LEDs unlit and the L LED in green.
(5)
Now that the device has been reset with the factory default settings, you can access it through the IP (the
device's default address is 192.168.1.1 and is accessible from any switch port).
3.5 Connecting the data
The Regesta PRO PLC router has the following data connections.
3.5.1 Ethernet port
The Regesta PRO PLC router incorporates a 10/100 BaseT Ethernet port with automatic MDI/MDIX to connect to a
local area network (LAN). The LED labeled "E" indicates physical connection.
Fig. 11:
LAN port
3.5.2 WWAN antenna connection (RF connectors)
The Regesta PRO PLC router has two RF antenna connectors. The antennas are assembled and disassembled by
screwing/unscrewing them into the connectors labeled RF1/RF2 on the front panel of the device.
The RF1 connector is connected to the module’s MAIN connector and the RF2 connector to the AUX connector.
Using these antennas with the Regesta PRO PLC router improves the quality of the signal received and transmitted
by the WWAN module (GPRS, UMTS, HSDPA, HSUPA, etc.).
Fig. 12:
WWAN antenna connectors
3 Components and power supply
Teldat S.A.
14
Regesta PRO PLC
