Telcoma Automations EDGE20, Инструкции по эксплуатации и программированию

Страница: 38 / 64

GB GB
- Channel 00 repetition This new multi-channel control enables
programming of channel 00 so that it repeats transmission sequentially for
a set time interval.
This function is useful when channel 00 is optimised for centralised
commands, and repetition optimises reception of the radio signal.
Press key 5 to select
Press key 5 to confirm. The text appears briefly and the radio
control returns to normal operating status.
In this case (30) channel 00, after pressing a transmission key, is
transmitted at regular intervals for 30 seconds. On each
transmission, the text is displayed, followed by . Press
key 1 or 3 to interrupt transmission repetition.
To disable repeated transmission of channel 00, set in the
menu .
- CETAP control unit compatibility (for EDGE20 only)
To enable recognition of the central key (5) as a STOP key on the CETAP
control unit, enter the menu and proceed as follows:
Press key 5 to select
Press the central key to confirm.
To disable CETAP compatibility, repeat the operations above and
select
Press key 2 (indicated in the drawing) or 4 until is displayed
Use key 2 (indicated in the drawing) or 4 to scroll through values
00 to 40.
Select 00 to disable transmission repetition.
Select 10, 20, 30 or 40 to set the repetition interval in seconds.
- Firmware Version
Press key 5 to select . This displays a number corresponding
to the radio control firmware version.
DUPLICATING A RADIO CONTROL (for EDGE20 only)
This procedure describes how to copy all codes of another EDGE20 or
previous model (TANGO20) onto an EDGE20 radio control.
From any selected channel, press and hold key 3 and at the
same time press key 1 four times.
Release key 3.
The letter starts flashing on display.
38 39