Tektronix WFM 601i, Руководство пользователя

Страница: 69 / 135

Functional Overview
WFM 601i Serial Component Monitor
2–17
A special condition exists when PARADE or WAVEFORM overlaid mode
display is selected. The first line in the display corresponds with the LINE
SELECT readout. The second is the from the next line and finally the last third
of the display is from the third line in the sequence. See Figure 2-10.
.7
.6
.8
.5
.4
.3
.2
.1
–.1
–.2
–.3
Tek
COMPONENT ANALOG
2% & 4% K
PB
100%
50%
Line 1
Line 2
Line 3
F1:181
(181) (182) (183)
Figure 2-10: Parade display of YP
B
P
R
shown in line select.
CLEAR MENU removes the readout associated with the line selection, but the
line number readout and Line Sel control assignment remain active and on
screen. To restore the menu readout, push the LINE SEL menu button again. To
turn off the function push the LINE SEL menu button when the menu readout is
displayed (two pushes of the LINE SEL button if the menu readout is not
displayed).
The Preset menu makes it possible to recall a preset measurement from a list of
10 possible front–panel setups. Nine of these front–panel set ups can be used for
storage of front–panel setups. The remaining one is factory programmed to assist
in the calibration of the instrument.
When the PRESET menu button is pushed a list of the 10 presets appears over
the 2nd knob below the CRT. Rotating this knob moves the highlight box up or
down the list. Once the desired preset location is selected, one of four actions can
be taken:
RECALL – Sets the front panel to the stored settings previously loaded
into that memory location.
STORE – Wipes out the currently stored settings, in the selected
memory location, and replaces them with the current front–panel
settings.
Preset Menu