Reference
Recall Waveform
The Recall Waveform action recalls a waveform
fi
le from a USB
fl
ash drive to a
location in reference memory.
Options
Settings or submenus
Comments
To
Ref(x)
Speci
fi
es the reference memory location
to load the waveform to
From File
Recalls the
fi
le from the USB
fl
ash drive
Lists the contents of the current USB
fl
ash drive folder and displays the next
folder option
Change Folder
Utilities for the USB Flash Drive
Select File
To
Speci
fi
es the reference memory location
to recall the waveform to
Recall
fi
lename (such as
TEK0000.CSV)
Loads the waveform from the speci
fi
ed
fi
le to the location in reference memory
and displays the waveform
Key Points
Saving and Recalling Setups.
The complete setup is stored in nonvolatile memory.
When you recall the setup, the oscilloscope will be in the mode from which the
setup was saved.
The oscilloscope saves the current setup if you wait three seconds after the last
change before you power off the oscilloscope. The oscilloscope then recalls this
setup the next time you apply power.
Recalling the Default Setup.
You can push the
Default Setup
button to initialize
the oscilloscope to a known setup. To view option and control settings that the
oscilloscope recalls when you push this button, refer to
Appendix D: Default Setup.
Saving and Recalling Waveforms.
The oscilloscope must display any waveform
that you want to save. Two-channel oscilloscopes can store two reference
waveforms in internal nonvolatile memory. Four-channel oscilloscopes can store
four, but only display two at a time.
The oscilloscope can display both reference waveforms and channel waveform
acquisitions. Reference waveforms are not adjustable, but the oscilloscope
displays the horizontal and vertical scales at the bottom of the screen.
w w w . e k t
2
. c o m
Electronics
Katrangi
Trading