Getting Started
WARNING.
Observe all safety precautions listed in this manual before using this product and any associated instruments.
Although some instruments and accessories would be used with non-hazardous voltages, there are situations where
hazardous conditions may be present. This product is intended for use by quali
fi
ed personnel who recognize shock hazards
and are familiar with the safety precautions required to avoid possible injury. Read and follow all installation, operation, and
maintenance information carefully before using the product. Refer to this manual for complete product speci
fi
cations. Before
performing any maintenance, disconnect the line cord and all test cables. Operators of this instrument must be protected
from electric shock at all times. The responsible body must ensure that operators are prevented access and/or insulated from
every connection point. In some cases, connections must be exposed to potential human contact. Product operators in these
circumstances must be trained to protect themselves from the risk of electric shock. If the circuit is capable of operating at or
above 1000 volts, no conductive part of the circuit may be exposed.
WARNING.
Use properly rated load wires. All load wires must be heavy enough not to overheat when carrying the maximum
short-circuit output current of the power supply. If there is more than one load, then any pair of load wires must be capable
of safely carrying the full-rated short-circuit output current of the power supply.
WARNING.
Do not loosen any screw on this product. There are no user serviceable components inside.
WARNING.
To reduce risk of
fi
re and shock, ensure the mains supply voltage
fl
uctuations do not exceed 10% of the
operating voltage range.
Installing the System
This section contains information on how to install your PWS2000 power supply.
Unpack
the
instrument
and
check
that
you
received
all
the
items
listed
as
standard
accessories.
Check
that
you
also
received
any
other
accessories
that
you
ordered
with
your
instrument.
Check
the
Tektronix
Web
site
for
the
most
current
information.
To verify that the power supply is ready to use, follow these procedures:
Powering the Instrument On and Off
To power on the instrument follow these steps:
1.
Make all the connections.
2.
Properly set the 110 V / 220 V selector switch on the bottom of the instrument.
PWS2185, PWS2323, PWS2326, and PWS2721 User Manual
3
Содержание PWS2185
Страница 2: ......
Страница 3: ...PWS2185 PWS2323 PWS2326 and PWS2721 Linear DC Power Supplies ZZZ User Manual xx...
Страница 6: ......
Страница 8: ...Table of Contents ii PWS2185 PWS2323 PWS2326 and PWS2721 User Manual...