Tektronix PS 503A, Инструкция по эксплуатации

Страница: 27 / 57

Maintenace and Interfacing Information—PS 503A
gray connector two of the wires. Insulate the bare ends of
the wires.
Connect the remote load between pin 21A (4-Volts
supply common) and pin 22A (4-Volts supply output) and
between pin 21 B (—Volts supply common) and pin 22B
(-Volts supply output) on the interface connector.
Connect interface connector pins 24A and 24B to both
pin 21A (4-Volts supply common) and pin 21B (-Volts
supply common) at the remote load connection.
Connect interface connector pin 23A (4-Volts supply
sense input) to pin 22A (4-Volts supply sense output) and
pin 23B (—Volts supply input) to pin 22B (—Volts supply
output)
at the remote load connection.
Install a 50
/
j
F,
25 V d c (minimum rating) capacitor
across the remote load. To stop oscillations caused by
lead length an additional capacitor may be needed across
the points marked CF4- and CF—.
REPACKAGING FOR SHIPMENT
If the Tektronix instrument is to be shipped to a Tektronix
Service Center for service or repair, attach a tag showing:
owner (with address) and the name of an indivdual at your
firm that can be contacted. Include complete instrument
serial number and a description of the service required.
Save and re-use the package in which your instrument was
shipped. If the original packaging is unfit for use or not
available, repackage the instrument as follows:
Surround the instrument with polyethylene sheeting to
protect the finish of the instrument. Obtain a carton of
corrugated cardboard of the correct carton strength
and having inside dimensions of no less than six inches
more than the instrument dimensions. Cushion the
instrument by tightly packing three inches of dunnage
or urethane foam between carton and instrument, on all
sides. Seal carton with shipping tape or industrial
stapler..
The carton test strength for your instrument is 200
pounds.
4-5