9GB Disk Drive Upgrade
4
PDR 200 9GB Disk Drive Upgrade
Installation Procedures
The procedures that follow take you step by step through the installation of the
9-GB Disk Drive Upgrade into your PDR200. The physical installation of the
upgrade involves the following tasks:
• Removing the top covers.
• Removing the two disk drives adjacent to the SCSI board connectors.
• Installing the SCSI cable.
• Installing the disk drive caddies previously removed and the four new ones.
• Reassembling the PDR200.
• Creating a new disk file system.
• Reinstalling the PDR200 in the rack.
NOTE: Do not discard any items unless instructed to do so. Meeting EMI
specifications for the Profile system requires replacement of all chassis
screws.
Before You Begin
Tektronix recommends that you remove the PDR200 from the rack and place
it on a suitable work surface such as a table or workbench. The installation
instructions assume that the PDR200 rests on a flat surface.
WARNING: The PDR200 is too heavy for one person to remove from an
equipment rack. To avoid possible injury, get help when removing the
PDR200 from the rack.
To remove the PDR200 from the rack:
1. Shut down the PDR200, unplug the power cord and disconnect all cables
from the rear panel.
!
