9GB Disk Drive Upgrade
8
PDR 200 9GB Disk Drive Upgrade
SCSI Cable Installation in a 4-channel PDR200
The following assumes that you have upgraded from a 2-channel Profile system
to a 4-channel Profile system. The Slave EDR board controls the four drives
you are installing. The PCI board, which connects over the top of the Master
and Slave EDR boards, must be removed to install the SCSI cable on the Slave
EDR board.
For a 4-channel PDR200:
1. Remove the adhesive backing on the cable clamp and attach it to the top of
the power supply parallel to and adjacent to the existing clamp.
2. Connect one end of the SCSI cable to the unused connector on the SCSI
backplane. See Figure 5.
Figure 5. 4-channel PDR200 SCSI Cable Installation
3. Position the cable in the clamp so that both SCSI cables are parallel.
9979-7
