Tektronix IsoVu TIVM Series, Руководство пользователя

Страница: 66 / 82

User service
Position: 0 (centered)
Offset: -500 mV
Deskew: 0 seconds
5. Set the Horizontal menu to the following setups:
Horizontal Scale to 10 ns/div .
Horizontal Position: 40 ns
Acquire: Average 128
6. Set the Tek-DPG to the following setups:
0 to -1 1kHz mode (Mode 1)
Output Enable: ON
7. The Channel 1 waveform should appear approximately on the center of the
oscilloscope display. If the waveform is not vertically centered in the display,
adjust the display as necessary to vertically center the waveform.
8. Use the following steps to save the Channel 1 waveform as the reference
waveform (R1).
Press MENU on the oscilloscope.
Select Save Waveform .
Source: CH1 .
Destination: R1 .
Select OK Save to save the Channel 1 waveform as reference waveform
R1. The new reference waveform should now be displayed on the
oscilloscope.
9. Disable the output of the Tek-DPG.
10. Disconnect the Tek-DPG Deskew Pulse Generator output BNC cable from
the Channel 1 input of the TekVPI oscilloscope.
Create the TIVM series
waveform
Complete the following steps to set up the TIVM series waveform:
1. Connect the Comp box of the TIVM series measurement system to Channel 1
of the TekVPI oscilloscope.
2. Connect a IVTIP1X sensor tip cable to the TIVM series input (tighten the
SMA connector from the cable to the sensor head and attach the nose cone.)
3. Allow the measurement system to warm up for 20 minutes at an ambient
temperature of 20 ° to 30 °C.
4. Connect an MMCX Jack (female) to BNC female adapter to the output BNC
cable of the Tek-DPG.
48 TIVM Series Measurement System User Manual