Tektronix H600 RFHawk, Руководство по обслуживанию

Страница: 84 / 109

Lithium-Ion Battery Maintenance
Keep the battery away from children.
Do not use a damaged battery.
If a battery pack is leaking fl uids, do not touch any fl uids. Properly dispose of
a leaking battery pack (see Disposal and Recycling in this document).
WARNING.
In case of eye contact with battery fl uids, do not rub eyes. Immediately
fl ush eyes thoroughly with water for at least 15 minutes, lifting upper and lower
lids, until no evidence of the fl uid remains. Seek medical attention.
Transportation
Always check all applicable local, national, and international regulations
before transporting a Lithium-Ion battery.
Transporting an end-of-life, damaged, or recalled battery may, in certain
cases, be speci fi cally limited or prohibited.
Disposal and Recycling Lithium-Ion batteries are subject to disposal and recycling regulations that
vary by country and region. Always check and follow your applicable
regulations before disposing of any battery. Contact Rechargeable Battery
Recycling Corporation (www.rbrc.org) for U.S.A. and Canada, or your local
battery recycling organization.
Many countries prohibit the disposal of waste electronic equipment in
standard waste receptacles.
Place only discharged batteries in a battery collection container. Use electrical
tape or other approved covering over the battery connection points to prevent
short circuits.
H600 and SA2600 Instrument-Speci fi c Battery Maintenance
Instrument Run Time
The instrument run time depends on power consumption, which in turn depends
on the instrument measurement mode. For example, DPX™ Spectrum Display,
Spectrum analyzer, and audio demodulation measurements consume more power
than other measurements because they are continuously acquiring data.
With two new, fully charged batteries, you can run the DPX Spectrum
Display measurement for approximately four hours, or the Spectrum analyzer
measurement for
fi ve to six hours. Both of these run times are with the instrument
power management mode disabled. Enabling instrument power management
increases the instrument run time.
4–26 H600 & SA2600 Service Manual