Getting Started
10
P6467 High-Speed Probe Adapter Instruction Manual
If you intend to use the 92LANP application software with the P6467 Support
software, refer to the software installation instructions in the 92LANP Instruction
Manual to install the 92LANP software on the logic analyzer.
Configuration
Before you can acquire data with the P6467 probe you must determine how you
want to use the probe, adjust the clock threshold voltage, and then set up logic
analyzer to acquire data.
If you have not already done so, configure the clock jumpers on the probe
following the instructions under Configure and Install the Probes beginning on
page 3.
You can adjust the threshold voltage of the clock inputs on the P6467 probe to
meet the needs of your application. You only need to adjust the threshold voltage
on the Master Clock probe. When shipped from the factory, the theshold voltage
is set to 2 V.
To adjust the threshold voltage connect a digital voltmeter from test point THLD
and the adjacent ground pin. The location of test point THLD is shown in
Figure 4 on page 6. Adjust the threshold control (THLD ADJ) for a reading
between –1.6 V and +2.6 V.
Setting up the logic analyzer consists of defining the Setup menus. The P6467
software contains an example of a setup file that you can restore from the
hard disk.
The following steps summarize the basic setups, if necessary, refer to the 92A96
& 92C96 Module User Manual for detailed information on using the Setup
menus of the logic analyzer.
1. Use the System Configuration menu to define the cluster setups.
a. Separate the 92A96 Modules into two separate, one-card, two-card, or
three-card modules.
b. Specify a cluster for the modules.
2. Use the Cluster Setup menu to correlate the two modules and to define the
signals between the two modules.
3. For each module, use the 92A96 Configuration menu to specify the
acquisition memory depth.
Configure the Probe
Hardware
Adjust the Probe
Threshold Voltage
Set Up the Logic Analyzer
Содержание 070-9176-00
