TEKTELIC Communications Kona, Техническое справочное руководство, Страница: 33 / 34

Kona Home Sensor TRM T0005370_TRM Version Rev-C 1.0
TEKTELIC Communications Inc. Confidential Page 33 of 34
3.5
Sensor Command and Control
Configuration changes are not retained after a power cycle unless they are saved in the Flash
memory. Table 3-18 shows the structure of the Command & Control Register.
Ensure that the Sensor is properly configured before sending any of the following messages!
Failure to do so may irreparably damage the Sensor.
Table 3-18: Sensor Command & Control Register
Address Access Name Size
[Bytes] Description Format
0x70 W Flash Write
Command 2 Bit 0: Restart Sensor
Bit 13: Write App Config
Bit 14: Write LoRa Config Assert Bit Field:
0 = de-asserted
1 = asserted
Note: The Command & Control Register is always executed after the full DL configuration
message has been decoded. The reset command should always be sent as an “unconfirmed” DL
message. Failure to do so may cause your NS to continually reboot the Sensor.
3.5.1 Command Examples
In the following examples, the Command Field is boldfaced:
•
Write Application Configuration to Flash
o
DL payload: { 0x F0 20 00 }
•
Write Application and LoRa Configurations to Flash
o
DL payload: { 0x F0 60 00 }
•
Reboot Device
o
DL payload: { 0x F0 00 01 }