7
Inserting/Changing the Batteries
1. Open the battery compartment at the back of the device by pushing the battery
cover labeled “Open” downward (this area features
raised marks for easy identification).
2. Insert 3 AAA (1.5 V) batteries in the
battery compartment; make sure to match
up the symbols (+/–).
3. Close the battery cover by carefully placing the
stud into the slot in the rear area and
sliding it upward, applying slight pressure.
4. Follow the same procedure when replacing the batteries as needed.
Always read and follow the specific instructions of the battery manufacturers.
Note:
Always use only 3x1.5V(AAA) batteries.
• Keep away from children.
• Do not recharge.
• Do not short-circuit.
• Do not throw into a fire.
• Please recycle. Do not dispose of old batteries with your household waste; dispose of
them safely at your recycling centre or business where the batteries were purchased.
Preparing the Skin for a Session
Proper preparation of the skin covered by the electrodes allows more stimulation to reach
targeted tissues, prolongs electrode life, and reduces the risk of skin irritation. Wash the area
with mild soap and water (don't use alcohol). Rinse and dry thoroughly.
Make sure that your skin is clean and free of oil
Setting-up the Shorts
1. Turn the short inside out and lay on a flat surface.
2. Bend the electrode slightly and insert into the pockets with the gray side down and black
side up. Insert one electrode in each of the electrode holders,sliding the electrode under the
pocket lip.
3. Insert pin-end of the four lead-wires through the eyelet hole on the outside of the
shorts. This can be done on the left-side or right-side depending on which pocket you
prefer to put the device in during your session.
4. Slide one Blue tip wire over and out of the upper right eyelet hole. Slide the other Blue tip
wire down and out of the lower right eyelet hole. Slide one Black tip wire out of the
upper left eyelet hole. Slide the other Black tip wire down and out of the lower left
eyelet hole.
5. Insert the pin-end of the lead-wire snugly into the electrode. Repeat for all wires.
Make sure the wires are completely inserted into the electrode.
6. Apply a small ( dime size) amount of the conductive gel on the electrodes with your
finger, smear the gel around covering entire surface of the electrode.
7. Turn the short right side out and slide onto your body, pulling them up from the waistband.
Try to keep the electrodes away from contacting your gluteus until the shorts are
completely on. (In the event that some gel gets on your leg in the process of pulling the
shorts up, simply wipe it off with a cloth.)
The electrodes will need to be touching your bare skin in order to create a contraction. You may
want to wear a thong if you do not feel comfortable wearing the compression shorts without
undergarments. You might need to adjust the position of the garments slightly until you find
the most comfortable position. However the positioning will become much easier after a few
sessions. For reasons of Hygiene, please do not share Well Life Buttock Muscle Stimulator and
its accessories with others, for single person use only !
Содержание Contour
Страница 1: ......
