105-0717-006 17
Stop on JAW Travel
Stop screw is located at the end of the number 2 slideway, and number
4. The screw prevents jaw slides being unwound from the chuck. Do
not exert pressure against the screw with pinion action. If screw is
removed for disassembly it must be replaced before use. Refer
exploded view diagram on page 5 of the manual, and to drawing
accompanying insertion of jaw slides below.
Caution:
Do not close jaw slides to a diameter less than 8mm (5/16”)
for work holding. Do not close jaw slides to fully closed position
because jaw slides could over travel on scroll and become
disengaged.
Insertion of jaw slides
Jaw slides are numbered 1 - 4 (numbering on end of slide). (Note:
Travel stop screws need to be removed. Refer to previous jaw slide
travel lock section). When the jaws are removed from the body they
need to be reset in sequence. To reset jaws in chuck body, rotate with
pinion gear until the lead of the scroll (like a thin wedge) appears in the
opening of the slide way # 2.
CAUTION:
IT IS IMPORTANT TO ROTATE THE LEADING EDGE OF
THE SCROLL BACK SLIGHTLY TO CLEAR THE SLIDEWAY
BEFORE SLIDE CAN BE INSERTED. FAILURE TO ROTATE THE
SCROLL BACK COULD RESULT IN DAMAGE TO SCROLL.
Now insert No.2 slide into slideway and rotate scroll in a clockwise
direction (chuck facing you) until the lead of the scroll appears at the
next slideway. Now engage No.3 scroll in the same manner as No.2.
Proceed in the same way in a clock-wise sequence with No.4 and No.1
slides. Refer to the diagram.
