Teknatool nova ORION 55250, Руководство по эксплуатации

Страница: 13 / 38

13
128-1019-004
Connecting to Power
Warning!
Improper power connection may result in a risk of electrical hazard .
Before plugging the NOVA Orion lathe into the power source:
1. The main power switch is turned off
2. Power source is switched off
Socket type power cable
Hardwired power cable
Note: This image on the left-hand side is the European version of the NOVA Orion wood lathe. Other versions will have
a hard-wired power cable (shown on the image on the right-hand side)
The power cord that is installed on the NOVA Orion lathe will have a three-prong plug which includes a ground
prong. The plug must be connected to a matching outlet that his properly installed and grounded in accordance
with local electrical codes.
For 115V Outlet Only:
A temporary adapter can be used to plug into a two-pole outlet if a three-prong outlet is unavailable in your
environment. The ground tab on the adapter must be connected to the screw on the outlet for proper grounding.
This adaptor should only be used until a qualified electrician can install a properly grounded outlet.
➢
Note: If an extension cable is required, make sure to check the following:
1. Extension cable gauge
2. Is the cable properly insulated?
If in any doubt, please contact your local electrician to inspect the cord according to the local electrical standards
before using it.
❖
IMPORTANT:
•
A surge protection device must be used when using the lathe.
•
A surge protection device must be rated to at least 15A should be used in countries where 115V are used
as a standard. In countries where 240V is used, a surge protector must be rated to either 10A or 15A.
•
A surge protector with Joules rating of 3900J will be suitable for DVR motors.
Make sure the “O” side of the
rocker switch is pressed in before
connecting the power cable to the
power source.