Teka HGR 650 230 NAT, Инструкция по эксплуатации

Страница: 11 / 31

INSTALLATION LOCATION
In order for the gas unit to work properly it is essentital that the air
necessary for burning the gas flows into the area naturally. The
installer must follow the safety norms for the country of installation.
The flow of air into the area must come directly througy openings
made in the exterior walls. These openings must have a free
passage section of at least 1 00 cm2 (one or more openings can be
made.) Products of combustion must be exhausted through a hood
connected to a fume flue or directly outside. In the event that it is
not possible to install the hood, it is necessary to use an electric
ventilation fan installed in the outside wall or window of the area so
long as there is an opening for air to enter the area in conformity
with current law. This electric ventilation fan must have a flow
capacity sufficient to guarantee that 3 to 5 times the volume of air
in the room is xechanged every hour.
ELECTRICAL CONNECTION
Electrical Connection Attention
: do not connect to the power
supply before you have finished connecting the oven and cooktop.
Make sure that installation and hook-up are performed by a
qualified technician in accordance with the manufacturer's
instructions and in compliance with local regulations. The installer is
responsible for the correct electrical connection and for the
observance of the safety rules. The oven must be connected to the
electricity supply by means of an all-pole disconnect switch with
minimum contact gap of 3 mm. The appliance must be earthed by
law.Do not use multiple sockets or extensions.After the oven has
been installed, the electrial componenets must be inaccessible.