This electric water heater should be installed in a solid wall. If the strength
of the wall can’t bear theweight equalling twice. The total weight of the
heater fully filled with water, it will be necessary to install a special support.
1.
3.
4.
Install the supply socket in the wall. The requirements for the socket are as
follows: 250V/10A, single phase, three electrodes. It is recommended to
place the socket on the right above the heater. The height from the socket
to the ground shall not be less than 1.8m (see Fig.3).
The heater can be installed, anywhere in the house not exposed to direct
sunlight or rain. However, in order to reduce the pipeline heat losses, the
installation position of the heater shall be closed to the location for use of
water as near as possible.
After selecting a proper location, determine the positions of the two installa-
tion holes used for expansion bolts with hook (determined according to the
specification of the product you select). Make two holes in the wall with the
right depth by drilling the correct size matching the expansion bolts
attached, insert the screws, place the hook upwards, tighten the nuts so that
they are firmly fixed, and then hang the electric water heater on it (see
Fig.2).
2.
Model
100
100
100
100
100
86.5
86.5
141.5
141.5
141.5
384
594
567
796
961
330.5
568.5
524.5
746.5
911.5
198
198
198
198
198
104.5
141
141
141
141
115
257
176
297
447
340
340
450
450
450
360
360
470
470
470
A
B
C
D
E
F
G
H
I
EWH 15 VR1.5
EWH 30 VR1.5
EWH 50 VR1.5
EWH 80 VR1.5
EWH 100 VR1.5
