3
1) BURNERS
A diagram is screen-printed above each knob on the
front panel. This diagram indicates to which burner
the knob in question corresponds. After having
opened the gas mains or gas bottle tap, light the
burners as described below:
- Manual ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
place a lighted match near the burner.
- Electrical ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
depress and release the ignition button.
- Automatic electrical ignition
Push and turn the knob corresponding to the required
burner in an anticlockwise direction until it reaches
the full on position (large flame fig. 1), then depress
the knob.
- Lighting burners equipped with flame failure
device
The knobs of burners equipped with flame failure
device must be turned in an anticlockwise direction
until they reach the full on position (large flame fig. 1)
and come to a stop. Now depress the knob in
question and repeat the previously indicated
operations.
Keep the knob depressed for about 10 seconds once
the burner has ignited.
Note: You are advise not to try and light a burner
if the flame divider (Burner Cap) is not correctly
place.
In the event of the Burner flames being
accidentally extinguished, turn off the burner
control and do not attempt to re-ignite the
burner for a least 1 minute.
HOW TO USE THE BURNERS
Bear in mind the following indications in order to
achieve maximum efficiency with the least possible
gas consumption:
- Use adequate pans for each burner (consult the
following table and fig. 2).
- When the pan comes to the boil, set the knob to
the reduced rate position (small flame fig. 1).
- Always place a lid on the pans.
- Use only pan with a flat bottom and in thick metal.
Burners
Power ratings
Pans Ø in (cm)
Ultra rapid
3700 ÷ 4000
24 ÷ 26
Rapid
3000 ÷ 3400
20 ÷ 22
Semirapid
1750
16 ÷ 18
Auxiliary
1000
10 ÷ 14
WARNINGS:
- Burners with flame failure device may only be
ignited when the relative knob has been set to
the Full on position (large flame fig. 1).
- Matches can be used to ignite the burners in a
blackout.
- Never leave the appliance unattended when the
burners are being used. Make sure there are no
children in the near vicinity. Particularly make
sure that the pan handles are correctly
positioned and keep a chek on foods requiring
oil and grease to cook since these products can
easily catch fire.
- Never use aerosols near the appliance when it is
operating.
- If the built-in hot plate has a lid, any spilt food
should be immediately removed from this before
it is opened. If the appliance has a glass lid, this
could shatter when the hot plate becomes hot.
Always switch off all the burners before closing
the lid.
USE
FIG. 1
FIG. 2
Содержание E/70 2G AI TR
Страница 28: ...28...
