Teka E/70 2G AI TR, Инструкции по установке и рекомендации по обслуживанию

Страница: 12 / 28

12
10) INSTALLING THE HOT PLATE
WITH THE BATTERY
Check that the appliance is in a good condition after
having removed the outer packaging and internal
wrappings from around the various loose parts. In
case of doubt, do not use the appliance and contact
qualified personnel.
Never leave the packaging materials (cardboard,
bags, polystyrene foam, nails, etc.) within
children’s reach since they could become
potential sources of danger.
The measurements of the opening made in the top
of the modular cabinet and into which the hot plate
will be installed are indicated in either fig. 9. Always
comply with the measurements given for the hole
into which the appliance will be recessed (see fig. 9
and 10).
The appliance belongs to class 3 and is therefore
subject to all the provisions established by the
provisions governing such appliances.
11) FIXING THE HOT PLATE
The hot plate has a special seal which prevents
liquid from infiltrating into the cabinet. Strictly
comply with the following instructions in order to
correctly apply this seal:
- Detach the seals from their backing, checking that
the transparent protection still adheres to the seal
itself.
- Overturn the hot plate and correctly position seal
“E” (fig. 11) under the edge of the hot plate itself,
so that the outer side of the seal perfectly matches
the outer perimetral edge of the hot plate. The
ends of the strips must fit together without
overlapping.
- Unscrew the ignition cap “T” (see fig. 14) and fit a
1,5 V battery (not included in the appliance) with
the positive “+” polarity turn inside. Rescrew the
cap.
- Evenly and securely fix the seal to the hot plate,
pressing it in place with the fingers.
- Fix the hob with the proper brackets “S” and fit the
prominent part into the porthole “H” on the
bottom; turn the screw “F” until the bracket “S”
stick on the top (fig. 12).
INSTALLATION
FIG. 14