12-
:
Set DMX value of channel 8 and channel 16 to 255, then all channels of the unit will return
to their standard home position.
Press
button for at least 5 seconds into offset mode to adjust the home position,
when you want to adjust pan and tilt home position, you should be run
mode first ,
the functions are shown below:
Press the
button for at least 5 seconds into offset mode, use
and
button
up to when the
is shown on the display. Pressing
button, the unit will
focus on the center position. Use
and
button to adjust focus, this settings only
for offset mode to adjust home position. To go back to the main functions without any
change after 8 seconds
Press the
button for at least 5 seconds into offset mode, use
and
button
up to when the
is shown on the display. Pressing
button and the display
will blink. Use
and
button to adjust the pan home position. Once the position
has been selected, press the
button to setup or automatically return to the offset
functions without any change press the
button again, To go back to the main
functions without any change after 8 seconds.
Press the
button for at least 5 seconds into offset mode, use
and
button
up to when the
is shown on the display. Pressing
button and the display
13-
will blink. Use
and
button to adjust the tilt home position. Once the position has
been selected, press the
button to setup or automatically return to the offset
functions without any change press the
button again, To go back to the main
functions without any change after 8 seconds.
Press the
button for at least 5 seconds into offset mode, use
and
button
up to when the
is shown on the display. Pressing
button and the display
will blink. Use
and
button to adjust the gobo home position. Once the gobo has
been selected, press the
button to setup or automatically return to the offset
functions without any change press the
button again, To go back to the main
functions without any change after 8 seconds.
Press the
button for at least 5 seconds into offset mode, use
and
button
up to when the
is shown on the display. Pressing
button and the display
will blink. Use
and
button to adjust the color home position. Once the color has
been selected, press the
button to setup or automatically return to the offset
functions without any change press the
button again, To go back to the main
functions without any change after 8 seconds.
You can operate the unit in three ways:
1. By master/slave built-in preprogrammed function
2. By easy controller
3. By universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show I250 on the
display and move all the motors to their ‘home’ position and you may hear some noises for
about 20 seconds. After that the unit will be ready to receive DMX signal or run the built-in
programs.
Once you control the unit by Built-In program, be sure the unit is setting on
mode
DMX RESET
4.3 Home Position Adjustment
MENU
Focus Adjust
MENU
DOWN
UP
ENTER
DOWN
UP
Pan offset
MENU
DOWN
UP
ENTER
DOWN
UP
ENTER
MENU
Tilt offset
MENU
DOWN
UP
ENTER
DOWN
UP
ENTER
MENU
Gobo offse t
MENU
DOWN
UP
ENTER
DOWN
UP
ENTER
MENU
Color offse t
MENU
DOWN
UP
ENTER
DOWN
UP
ENTER
MENU
5. How To Control The Unit
5.1. Master/Slave Built-In Preprogrammed Function
