Tegam 2711A, Руководство по эксплуатации

Страница: 30 / 98

3 - 4
3
B: LOCAL Select the front panel control when the instrument is in remote mode.
1: Ampl Set the magnitude of output waveforms.
2: Ofst Set the dc offset of output waveforms.
3: State Set the ac signal to zero while maintaining the dc offset level. The
deglitcher may be turned on or off.
4: Filter Select one of the two low pass filters (40kHz /700kHz) or off.
1: Ampl
→
2: Ofst
→
3: State
→
4: Filter
D: OUTPUT menu
Chapter 3 Front-Panel Menu Operation
System Control
A3: 10MHz Ref
1: Int Select the internal reference clock for the generator.
2: Ext Select the external reference clock for the generator.
1: Int
→
2: Ext
1: Int Select the internal sample clock source.
2: Ext Select the external sample clock source.
1: Int
→
2: Ext
1: RS232 Set the RS232 serial interface parameters.
2: GPIB Addr Set the GPIB bus address (0-30).
3: 10MHz Ref Select the reference clock source.
4: Sample Clock Select the sample clock source.
System Control
A: SETUP menu
1: RS232
→
2: GPIB Addr
→
3: 10MHz Ref
→
4: Sample Clock
A1: RS232
Select the baud rate of 1200, 2400, 9600, 19200.
Bits =8, Parity =None, Handshake =Hardware are not programmable.
A4: Sample Clock
1: 19200
→
2: 1200
→
3: 2400
→
4: 9600
Parameter Control (continued)