PRIOR TO USE
Review all product support materials with the Teeter Hang Ups Gravity Boots
and Inversion Table before inverting with the Teeter Hang Ups Conversion Bar.
1. Preparing the Inversion Table
• Confirm that the Main Shaft is adjusted to your proper height setting.
• Adjust the Ankle Comfort Dial (up or down) to ensure the hooks are securly
hooked to the Conversion Bar with the bar touching or nearly touching the base
of the hook while the feet rest flat on the Ankle Comfort Dial.
2. Mounting
• While facing away from the table with your legs positioned on either side of the
Main Shaft, lift one foot so that Gravity Boot Hook on the boot wraps around
the Conversion Bar.
• Slide the hook along the Conversion Bar until the foot is able to rest flat on
the Ankle Comfort Dial (Figure 4).
Figure 4
WARNING
!
Setting the Ankle Comfort Dial so that the hooks are not securely around the bar
could cause you to fall during inversion, resulting in serious injury or death!
International:
Inversion International, Ltd.
(Phone) +1-242-362-1001 · (Fax) +1-242-362-1002
[email protected] · www.InversionInternational.com
If you have any problems assembling the equipment or questions about its use, please contact customer service at:
USA:
Teeter
Toll Free (Phone) 800-847-0143 · (Fax) 800-847-0188
[email protected] · www.teeter-inversion.com
DO NOT DISCARD - KEEP FOR FUTURE REFERENCE
Teeter Hang Ups® is a registered trademark of Teeter © COPYRIGHT 2011, Teeter.. LB-1003 0511-4
To re-assemble the Ankle Clamps -
reverse the process
• Remove the black end cap from the back of the ankle clamp housing (Figure 5).
• Follow Step Three through Step One, reversing the installation process to remove the
Conversion Bar and re-assemble the rear and front ankle clamp assemblies (Figures 6 & 7).
• IMPORTANT FOR FRONT ANKLE CLAMP ASSEMBLY:
- Make sure that the holes in the front ankle clamp assembly
are on top (facing the same side as the locking pin).
- When inserting the bolt into the holes in the housing, be sure to slide
the bolt through the loops at the end of the spring and security cable.
You may need to use needle nose pliers to pull and align the spring
loop and cable with the bolt.
- Fasten securely with the nut. Test the installation of the front ankle
clamps to ensure there is spring-loaded tension.
- Replace the black end cap on the back of the ankle clamp housing.
• If you removed the locking pin when you installed the Conversion Bar, you MUST replace
it securely before using the ankle clamp assembly. Use channel locks or vise grips to ensure
that the locking pin is fully tightened. You may want to wrap the base of the locking pin
with a cloth to prevent cosmetic scarring when tightening.
RE-ASSEMBLING THE ANKLE CLAMPS
WARNING
!
Failure to properly re-assemble the ankle clamps, including the T-Pin,
could cause serious injury or death! Test the locking function of the
ankle clamp assembly prior to use.
Black End Cap
Black End Cap
Spring and Cables
Bottom of Ankle Housing
Figure 5
Figure 7
Figure 6
Conversion Bar
Gravity Boot
Hooks
Ankle Comfort Dial
