Teesa TSA3507, Руководство пользователя

Страница: 14 / 52

EN
Owner’s manual 14
• Don’t let the motor unit, cord, or plug get wet. Do not immerse the motor unit in water!
Do not handle the device with wet hands.
• Never use the device if the device itself or its cord have been damaged. Do not attempt
to repair/disassemble this device yourself. In case of damage, contact with an authorized
service point for check-up/repair.
• Don’t let excess cord hang over the edge of the table or worktop or touch hot surface.
• The appliance is constructed to process normal household quantities. Not for commercial use.
• Improper use of this device may lead to injuries and damages.
• Be careful while handling the blades, they are extremely sharp.
• Keep your fingers and kitchen utensils away from the moving blades / rotating whisk.
• Do not place any accessory of this device into microwave.
1. Before assembly, clean all the parts which will have contact with food. Be extremely
careful when cleaning the blades – they are sharp and can cause injury.
2. Mounting: Choose the attachment you want to use and follow the steps indicated below:
• Blender: Push the motor unit into the blending stick holder until it locks in place.
• Whisk: Push the motor unit into the whisk holder until it locks in place.
• Chopper:
a. Place the blade on the center pin of the chopper bowl. Be careful, the blade is
very sharp! Always hold it by the upper plastic part.
b. Once the blades are assembled, user should place the food ingredients into
the bowl.
c. Place the chopper bowl lid and turn clockwise until it locks in place.
d. Push the motor unit into the chopper bowl lid until it locks in place.
3. Plug the device into power mains socket.
Note: In case of using blender or whisk, insert the attachment into a container with food to
be processed. In case of chopper, the food needs to be inserted into the bowl after the blades
are assembled and before the lid and motor unit are mounted.
4. Set the adjustable speed knob to desired setting and press adjustable speed mode
button OR press Turbo mode button to start operation.
Note: user can freely change settings of the adjustable speed knob during operation when
using adjustable speed mode button (top button).
5. Use the blender no longer than 1 minute at a time. If within that period, the desired
effect has not been reached, stop operation and wait for about 1 minute before using
the device again.
Note : please regard 1 minute of operation and 1 minute of rest as a one operation cycle .
After continuous operating the device for 5 cycles (that is 1 min. operation followed by
1 minute rest, 5 times in a row), the blender must be left for cooling for about 30 minutes.
6. Unplug the device from power supply mains after operation.
OPERATION